Specifications
—
INSTALLATION AND WIRING
BDS0032 rev 3
ABB FusionAir Smart Sensor
©ABB 2021 All Rights Reserved.
Subject to change without notice
1
BDS0032 rev 3
DIMENSIONS
MOUNTING
• Install the FusionAir Smart Sensor on
an easily accessible interior wall,
approximately 60” (1.5 m) above the
floor in an area of average temperature
• Avoid direct sunlight or other heat
sources (e.g. the area above radiators
or other heat-emitting equipment)
• Avoid locations behind doors, on
outside walls and above or below air
discharge grills and diffusers
IMPORTANT NOTICE
AND SAFETY ADVICE
This device is for use as an
operating control. It is NOT
a safety device. Where a
device failure endangers
human life and/or property,
it is the responsibility of the
client, installer, and system
designer to add additional
safety devices to prevent a
system failure caused by
such a device failure.
Ignoring specifications and
local regulations may cause
equipment damage and
endangers life and property.
Tampering with the device
or misapplication will void
warranty.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
WARNING: Changes or modifications not expressively approved by the party responsible for compliance could void the
user's authority to operate the equipment.