Manualshelf

User Guide

ManualsBrandsAAXA Technologies ManualsElectronicsAAXA P700 WXGA LED Pico Projector, 650 Lumens, 70+ Min Battery, Native 1280x800 HD Resolution, 15,000 Hour LED, HDMI, Media Player, DLP
123
AAXA Technologies P700 HD LED Pico Projector - Troubleshooting Guide
Page 1 of 3
Troubleshooting
Image is blurred/Picture not bright enough
Possible Causes
Solutions
The Projector is not in focus
Adjust the focus with the focus adjustment dial
until the image comes into focus.
The Projector is offset from plane / angle of
operation
Move the projector so that it is both 180 degrees
and on an even plane with the screen.
The screen is too far away from the Projector
The projector has an image range of 10-150
inches. For best results, please refer to our throw
ratio chart on page #5 on the instruction manual.
A distance of 6-9 feet between the projector and
the screen will give you the best result. Anything
more than 6-9 feet will be best under low light
conditions.
Room lighting condition is too bright
The larger the projection is, the less bright the
projected image will be due to the lumens being
spread out. For best results, use the projector
under low lighting conditions and adjust the
projected image size accordingly.
Projector is on Battery/Eco Mode
Check to see if you are on the correct setting.
Eco (Battery mode) – Less bright
Normal – Normal brightness
Bright* – Slight boost to the brightness
*Caution: Not recommended to be used
for more than an hour to avoid
overheating.
The Projector does not turn on/charge
Possible Causes
Solutions
There is no power
Check to ensure the power outlet or battery
source is good. Check the power adapter to
ensure a proper connection with the wall outlet as
well as the projector. Confirm that the unit is
charged and has enough power by checking to see
if the LED light on the front right of the projector is
blue meaning the unit is fully charged.
The power switch is not turned on
To power on the projector, the power switch
needs to be switched to ON before pressing the
Power Button on top of the projector.
Projector does not run on battery
Check to see if the unit is receiving power from the
power adapter. When the battery is charging, the
LED indicator in the front right of the projector
should be on. Once it is fully charged the indicator
will turn blue.

Summary of content (3 pages)