Inari 8 Quick Start Guide Inari features, buttons & interfaces Front 2 1 1 Ambient Light Sensor 3 4 6 5 Recognizes the ambient light and adjusts the display brightness if enabled in the operating system 2 3 Front microphone outlet Front camera 2MP camera for video conferencing 4 Camera Indicator LED Lights up if camera is activated and during device boot and shutdown 5 Charging indicator LED OFF ORANGE GREEN RED 6 not connected to charger charging connected and fully charged charge fault Wi
Top side 7 7 8 On / Off Button Push it once to start the tablet; push it again to enable the sleep mode. Push and hold it to shut down the device. 8 Volume key Push the left side to reduce the volume, use the right side to increase the volume Right and Bottom side 9 14 10 9 10 11 11 12 13 Docking connector MicroSDXC card slot MicroUSB interface For charging only! 12 13 USB 2.
Rear view 16 17 18 15 19 20 15 NFC antenna position Can be used to read NFC & RFID tags 16 17 18 Rear microphone outlet Camera flash LED Rear camera 8MP camera for high resolution images & video 19 20 Mechanical fixing points behind covers Battery lid 2
Replacing Battery / Adding SIM card To replace the battery, take of the battery lid by pulling on the lid carefully. Pull on the battery holder hook (1) to the bottom of the device. Pull the battery up (2), and pull on the second battery holder hook (3). Enter the SIM card into the slot in the bottom right corner. Please make sure you have the SIM card in the correct direction (chip facing down). When putting the battery back in place, please make sure both hooks have clicked and are safely secured.
Using the Tablet for the first time 1. Connect power supply for the first time and make sure battery is fully charged before disconnecting. 2. Press the power button 3. Follow the instructions in the operating system to complete the setup Troubleshooting In case devices freezes and you need to do a hard reset, press and hold the power button for approx. 14 seconds. Device will be turned off now.
Important Product and Safety information Do not drop, bend or twist your tablet. This can break tablet display glass, internal circuit boards or mechanics. If the glass breaks, do not touch the glass parts of the device or attempt to remove the broken glass from the device. Stop using the device until the glass is replaced by qualified service personnel. Do not try to disassembly your tablet. This may damage the device.
Warning Statements To prevent possible hearing damage, do not listen at high volume levels for long periods. WLAN 802.11 a/n bands are allowed for indoor use only. Antenna positions Your device meets guidelines for exposure to radio waves (SAR, Specific Absorption Rate) when kept in a minimum distance of 2.5cm to your body. It is recommended to learn the antenna positions (for 3G or LTE devices only) as mentioned below and not to touch or bring your body closer than 2.5 cm to these antenna areas.
EU Declaration of Conformity Hereby, Aava Mobile declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. FCC Compliance Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.
Canadian Compliance Statement This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de classe B est conforme à la norme NMB-003. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
9
10
11