User's Manual

Initial Setup
After this quick setup, you will be ready to enjoy your music wirelessly.
1) Plug in
Plug the 12V power end of the JamKast into your vehicle’s cigarette lighter port, or 12V power outlet.
Insert the Lightning connector from the JamKast into your iPod, iPhone or iPad.
2) Turn On
Press the center button to turn on the JamKast.
Operation
To begin enjoying your music using the JamKast, tune your vehicle’s radio to the frequency shown on
the LCD display, and press play on your iPod, iPhone or iPad.
Additional features for optimal operation
Autoscanning – The JamKast transmitter uses dTECT™ technology to locate and lock-in the four best stations
for music playback from iPod, iPhone or iPad.
1) Hold both the
+ and
-
buttons at the same time to activate dTECT™ scanning
2) PRESETS will blink for 20 seconds, while scanning
3) Scanning is complete when PRESETS stop blinking
NOTE: We recommend activating dTECT™ auto-scanning when you enter new geographical areas as you travel.
Selecting Presets
Use the
+
or
-
buttons to switch through the available presets.
Manual Tuning and Saving Presets
The JamKast transmitter allows you to manually tune to any frequency, and lock these frequencies into the preset memory.
1) Choose the PRESET that you want to change.
2) Press the center button once to enter manual tuning mode.
3) Use the
+
or
-
buttons to change to the desired frequency.
4) Press the center button once again, to lock the station into the PRESET memory.
Tech Support:
[e-mail]
866-788-4237
WARNING:
This equipment may be reset by unintentional electrostatic discharge during operation. Exposure to direct sunlight or extreme heat may cause damage or
malfunction.
FCC Class B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party responsible compliance could void the user authority to operate the equipment.
JamKast
FM Transmitter with Lightning Connector for iPod, iPhone or iPad
IN-CAR CONNECTIVITY
ISFM75
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)ÿThis device may not cause harmful interference,
(2)ÿand (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.