User's Manual

A&D Company,Limited
4
AD1321A Wireless Module Specification
概要 OUTLOOK
２．４ＧＨｚ帯のＩＳＭバンドを用いた出力１０ｍＷの汎用の無線モジュール。外部アンテナ端子を持ち、
モジュールはＡＴコマンドで制御でき、シリアル通信のＳＰＩ（ＣＳＩ）のプロトコルでデーターを送る。
This is a general-purpose wireless module with an output of 10 mW using the 2.4 GHz
ISM band. It has an external antenna terminal, this module can be controlled by AT
command, and sends data by SPI (CSI) protocol of serial communication.
1, 注意事項 CAUTION & NOTE
FCC CAUTION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interferen
ce
r
eceived, including interference that may cause undesired operation.
本モジ
ュールを最終製品に組み込む時、以下の文言を製品マニュアルに明記下さい。
The following statements must be described on the user manual of the host device of this module.
 Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low level
s
of
RF energy. But it is desirable that it should be installed and operated keeping the radiator at
least 20cm or more away from person's body.
FCC NOTE
 This device complies with below part 15 of the FCC Rules.
Part 15 Subpart C
 本モジュールを最終製品に組み込む時、括弧内の文言を製品に明記して下さい。
W
hen you use this module in your products, Please specify as follow sentence to your product.
・ [Contains Transmitter Module FCC ID:KSNAD1321A] or [Contains FCC ID:KSNAD1321A]
・ [This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.]
 本無線モジュールはFCCに認可されたものです。本無線モジュールを搭載製品の製造者は他のFCC
規則に準拠させる責任があります。
そし
て、本モジュールを搭載した最終製品はFCC15Bの適合性試験を受ける必要があります。
This wireless modular is only FCC authorized for the specific rule parts (i.e., FCC transmitter
rules) listed on the grant, and the host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host product not covered by this wireless modular grant of
certification.
The final host product still requires Part 15 Subpart B compliance testing with this wireless
module installed.