Module: LM003 UIP4RF55 User Manual April 2021 Version 1.
| 3 Copyright Copyright © 2021 4RF Limited. All rights reserved. This document is protected by copyright belonging to 4RF Limited and may not be reproduced or republished in whole or part in any form without the prior written permission of 4RF Limited. Trademarks Aprisa and the 4RF logo are trademarks of 4RF Limited. Windows is a registered trademark of Microsoft Corporation in the United States and other countries. All other marks are the property of their respective owners.
| Compliance General The Aprisa UIP4RF55 module operates within frequency bands that are controlled through spectrum license managed by the carriers1 . Devices using these frequencies must meet the FCC regulatory requirements in addition to any requirements put in place by the carriers. It is the responsibility of the user, before operating the equipment, to ensure that where required the appropriate regulatory and regional carrier requirements have been met.
| 5 Symbols ISO 7000-0434B Exposure Warning Avertissement d'exposition IEC 60417-5041 Potential hot surface hazard Risque potentiel de surface chaude ISO 7000-0434B Read the instructions Lis les instructions Aprisa UIP4RF55 Module User Manual 1.
| RF Exposure Warning WARNING: To comply with FCC/ISED regulations limiting maximum RF output power, human exposure to RF radiation, and possible antenna co-location interaction, the antenna gains and resulting EIRP must not exceed those stipulated in Table 3. At least 20 cm (8 inches) separation distance between any antenna used with this device and the general public must be maintained at all times when using antennas with gain up to the Maximum MPE Antenna Gain values shown below.
| 7 Table 3 Antenna Compliance Requirements Operating Mode Tx Freq Range (MHz) Max Time-Avg Cond. Power (dBm) LTE B2 1850 - 1910 LTE B4 Maximum MPE Antenna Gain b Standalone (dBi) Co-located (dBi) 24 8 6 1710 – 1755 24 6 4 LTE B5 824 – 849 24 6 4 LTE B7 2500 – 2570 9 4 LTE B8 (USA) 23.8 a 880 – 915 (897.5 – 900.
| Installation The Aprisa UIP4RF55 module is intended for installation in the Aprisa LTE router by a qualified technician. The module must be unpacked at a static protected workstation. Ensure that the Aprisa LTE is powered off. Open the Aprisa LTE case and locate the LTE M.2 module slot. This is a M.2 standard Slot B notched PCI Express NGFF 75 pin position connector on the Aprisa LTE main board.
| 9 Open Source License Statement This product contains open source software. Full details and license terms are provided in the separate document Aprisa LTE Open Source License Statement. This document is available at www.4rf.com/oss and at www.github.com/4rf/lte. Trademarks and Service Trademarks LTE™ is a trademark of ETSI, used with permission for Aprisa products containing LTE functionality OpenVPN® is a registered trademark of OpenVPN Inc, AT&T is a trademark of AT&T Intellectual Property II., L.P.
| Aprisa LTE User Manual Product End Of Life End-of-Life Recycling Programme (WEEE) The WEEE Directive concerns the recovery, reuse, and recycling of electronic and electrical equipment. Under the Directive, used equipment must be marked, collected separately, and disposed of properly.