User's Manual

ManualsBrands3M Traffic Safety Systems ManualsElectronicsUSB RFID Reader

Rhein Tech Laboratories, Inc. Client: Sirit Technologies Inc.

360 Herndon Parkway Model #: PnP USB

Suite 1400 Standards: FCC 15.225 & RSS-210

FCC/IC ID: M4ZPNPUSB/3637B-PNPUSB Herndon, VA 20170

http://www.rheintech.com

Report #: 2006114

Page 27 of 36

Appendix I: Manual

Please refer to the following pages.

Summary of content (7 pages)

PAGE 1
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix I: Client: Model #: Standards: FCC/IC ID: Report #: Sirit Technologies Inc. PnP USB FCC 15.225 & RSS-210 M4ZPNPUSB/3637B-PNPUSB 2006114 Manual Please refer to the following pages.
PAGE 2
PnP USB User Guide PnP USB User Guide Preliminary Document v0.10 Copyright Sirit Inc.
PAGE 3
PnP USB User Guide -2- Table of Contents 1 – PNP USB MODULE OVERVIEW..........................................................................- 3 1.1 Description ......................................................................................................................................................... - 3 1.2 PnP USB Start-Up Guide.................................................................................................................................... - 4 1.
PAGE 4
PnP USB User Guide -3- 1 – PnP USB Module Overview 1.1 Description Model Name: PnP USB RFID Reader Model Number: PnP USB FCC ID: M4ZPNPUSB Industry Canada ID: 3637B-PNPUSB Description: The Sirit PnP USB RFID Reader is a modular high-frequency radio frequency identification (RFID) reader operating in the 13.560 MHz ISM band. It is designed to interface to a host computer using USB protocol. It uses ISO 15693, 14443A and B, 18000-3 Mode 1, and several other proprietary protocols.
PAGE 5
PnP USB User Guide -4- 1.2 PnP USB Start-Up Guide Operational Sequence: First load software on the Host computer as per section below. Then plug USB module in to host computer. Start application program in host computer. Read RFID tags. Other information or help with this document or the module, please visit the Sirit website at www.pnprfid.com or email support at support@pnprfid.com. =========Host Software Setup========= 1.3 Loading Software into Host Computer ========= USB Reader Setup========= 1.
PAGE 6
PnP USB User Guide -5- 2- Hardware Description 2.1 Hardware The PnP USB module uses the Inside Contactless (France) PicoRead chip set consisting of the PicoRead RF processing chip and a custom programmed MicroChip Corporation (USA) 18F2550 micro controller unit (MCU). The USB interface uses a FTDI Chip (England) FT232BM chip to translate from the serial data stream of the PicoRead MCU to the host device USB interface. The host unit provides 5.0 volt power to the module.
PAGE 7
PnP USB User Guide -6- 3- Safety Instructions Power Disconnect Device This device gets its power from the host computer. Unplug the device to take power away from it. Do not use the device if it becomes wet. Do not use the device while it is immersed in water. WARNING: FCC Radiation Exposure Statement: This device emits low levels of RF energy when in operation. Do not allow the use of this device by someone using a cardiac pacemaker or other medical devices sensitive to RF energy.