User's Manual

MRz User Manual

Mi3c E-Passport Reader (MRZ, Smartcard)

MRz is Mi3(3M Cogent handheld device)’s plug-in module and it is easy-to-

use. It scans electronic passports and provides you with the passport image

and data into Mi3’s database and Mi3 Extracts passport's information data

like passport image and face image. Data and images scanned by MRz can be

sorted, retrieved, printed on and through MI3. It is easily and automatically

exported to various applications, emailed, and sent to an FTP or web address

directly from within the program. It only need

few seconds per scan and No

external power needed.

MRz has an RF module works at 13.56MHz. This part is made for reading IC

in passport. After swipe the barcode of passport and put passport IC side

PAGE 1
MRz User Manual Mi3c E-Passport Reader (MRZ, Smartcard) MRz is Mi3(3M Cogent handheld device)’s plug-in module and it is easy-touse. It scans electronic passports and provides you with the passport image and data into Mi3’s database and Mi3 Extracts passport's information data like passport image and face image. Data and images scanned by MRz can be sorted, retrieved, printed on and through MI3.
PAGE 2
close to the RF reader, MRz quickly analysis the data and read out the data before showing the data through MI3.
PAGE 3
Connect to MI3 Please refer to the pictures and follow steps to use it. 1 installs MI3 Passport Reader Module to Mi3. (Connect the interface ‘24pin’) 2 Starting up Mi3 and enterring into the MRz reader interface. (This is the step of using MI3, do not detail here) 3 swipe the magnetic _stripe in the swipe slot and wait for the software analysis. 4 put the passport close to the RF part and then you can see data shows in MI3.
PAGE 4
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.