User's Manual

BC2aUserManual



Bluecheck2,EIMUPEKsensor,WinCE6.0core

z Product Description

Weighing less than 5 ounces, 3M Cogent’s BlueCheck® II is the lightest,

ruggedized mobile device in the industry. It is available in 3 models, the

BlueCheckIIwithanFBI‐c ertified500ppiopticalsensor,theBlueCheckIIUwitha

PIV‐certified500ppisiliconsensorandtheBlueCheckII

Awith3MCogentApple

BluetoothCLASS 2Module.

BC2a is 3M Cogent latest version which mainly communicating with Iphone,

Itouchandsoon.Themainfunctionistocapturefingerprintsandsendimages to

Itouch though Bluetooth. The Bluetooth function inside BC2a is achived by 3M

Cogent Apple Bluetooth

class 2 module. It works at 2.4GHz and with BC05 and

16M Flash. Apple BTM v2.0 Module contain an integrated apple authentication

co‐processor, MFI341S2164. It supports for connecting to an apple iphone/ipod

touch/ipad by Bluetooth IAP protocol. BC2a has fully quality Bluetooth with

V2.1+EDRSpecificationsystem.

PAGE 1
BC2a User Manual Bluecheck 2,EIM UPEK sensor,WinCE 6.0 core z Product Description Weighing less than 5 ounces, 3M Cogent’s BlueCheck® II is the lightest, ruggedized mobile device in the industry. It is available in 3 models, the BlueCheck II with an FBI‐certified 500 ppi optical sensor, the BlueCheck II U with a PIV‐certified 500 ppi silicon sensor and the BlueCheck II A with 3M Cogent Apple Bluetooth CLASS 2 Module. BC2a is 3M Cogent latest version which mainly communicating with Iphone, Itouch and so on.
PAGE 2
z Operation Description 1 Press the silver button to start BC2a. 2 Open itouch and choose ‘Setup’‐‘General’‐‘Bluetooth’, Then Start Up Bluetooth Function. 3 Connect BC2a and itouch. Press the green button on the left until warning tone goes off. Choose the right device showing on the Itouch to complete the connection. 4 After connection, press ‘OK’ to input fingerprints. Remember twice inputs.BC2a will send fingerprint images to Itouch automatically through Blutooth.
PAGE 3
FCC Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.