User's Manual

page 1 of 6
3DGence | Przyszowice Office | Graniczna 66, 44-178 Przyszowice, Poland
www.3dgence.com
Headquarters: 3DGence Sp. z o.o. | Mickiewicza 29, 40-085 Katowice, Poland
KRS: 0000265431 | VAT-EU: PL6330009438 | REGON: 271077426
Share capital: 1.400.000 PLN
NFC Reader User Manual rev. 1.2
Supplier's Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier:
Trade name: NFC Reader rev 2.1,
Model number: F380.13.024
FCC ID: 2AU79-SMM01
IC: 25678-SMM01
Responsible Party – U.S. Contact Information:
3DGence America, Inc.
1841 E.Levee Street
75207 Dallas, TX
Telephone: [phone]
FCC Compliance Statement:
CAUTION: Changes or modifications not expressly approved could void your authority to use this
equipment
This device complies with Part 15 of the FCC Rules. Operation to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.