ASYCONTR EASYCONTROL4 OWNER’S MANUAL 3 BETRIEBSANLEITUNG 11 MODE D’EMPLOI 19 GEBRUIKSAANWIJZING 27 20096/130405 © ALL RIGHTS RESERVED MARMITEK ®
EASYCONTROL4 1 2 3 4 5 6 8 7 9 10 11 12 13 15 14 16 19 17 18 21 22 20 2 MARMITEK - NICOSHOP
• • • • • To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose the components to rain or moisture. Do not use the product close to a bath, swimming pool etc. Do not expose the components of your systems to extremely high temperatures or bright light sources. Do not open the product: the device contains live parts.
1. Foreword You can operate up to 4 devices with the EasyControl 4 remote control: TV, VCR (video recorder), DVD, SAT The remote control contains a large number of pre-programmed codes. These codes are suitable for almost all currently available devices and must be programmed once before use. There are various ways to do this: a. By manually entering one of the codes for the relevant brand that can be found in the accompanying code book (see figure 4.1). b.
ENGLISH [6] VOL +/Controls the volume. You can adjust the volume, also when you are in VCR, DVD or SAT mode. You do not need to switch over to TV mode. [7] INFO Provides on-screen information for the device selected (if available). [8] SETUP This is where you program the remote control for use. This button gives access to some of the secondary functions of certain audio/video equipment (Shift). Press the SETUP button and then the desired function button.
[18] F.F. (fast forward) In VCR, DVD or SAT mode: Works just like the button on the original remote control. In TV mode: Coloured button (blue), operates Teletext – or other device functions. [19] PLAY (play) In VCR, DVD or SAT mode: Works just like the button on the original remote control. In TV mode: Coloured button (yellow), operates Teletext – or other device functions. [20] STOP In VCR, DVD or SAT mode: Works just like the button on a normal remote control.
If your device (TV, satellite, etc.) does not respond, you can try another code for your brand. If the device does not react to any of the codes, then try the method in paragraph 4.4, Manually searching for codes. 4.
4.3 Automatically search for all brands When you are looking for an unknown code, you can automatically search through all the codes (AutoSearch). Note: Because you can assign every device (DVD, satellite) to the VCR, DVD - buttons, you first have to enter a 3-digit code for the type of device that you want to operate (see the code book). For example: If you want to program a satellite on the DVD button, you first have to enter a RANDOM satellite code from the code book and follow the following steps: 1.
If the batteries are taken out of the remote for a longer period, the programmed codes can be erased from the memory. Therefore it is wise to write down the codes, so you will be able to reprogram the remote control quickly If you don’t know the code (for example because you found the code by autosearch) you can identify it as described below: 1. Press and hold SETUP (8) until the LED indicator (2) lights steadily. Release SETUP. 2.
Returning the Easycontrol 4 to the original factory settings • Keep the SETUP (9) button pressed until one of the Mode LEDs stays lit. Release SETUP. • Press STOP (21) twice and release the button. • Press Mute (5) and release the button. • The LED will extinguish after a few seconds.