Install Instructions

Page | 1
Integration Instructions for installation of
RFID Reader, type 2N® LFHF SMD V1 2018
in a host product
Requirement 2.2 – List of applicable FCC rules
The following FCC rules are applicable to the equipment:
• CFR 47, Part 15, Subpart C, 15.209 – Radiated Emission Limits
• CFR 47, Part 15, Subpart C, 15.225 – Operation within the band 13.110-14.010 MHz
Requirement 2.3 – Summary of operational use conditions
Antenna configuration
The loop antennas are integral to the module board. The loop for the 125 kHz RFID Reader is a
coil that is soldered to the module PWB. The antenna for the 13.56 MHz RFID Reader is a coil
traced on the module PWB. These antenna configuration must not be altered when the module
is installed in a host product.
Requirement 2.6 - RF Exposure conditions
Installation instructions
The module is exempt from routine evaluation to rf exposure requirements. No rf exposure
warning is required for the module when installed in a host product.
Requirement 2.7 – Antennas
The loop antennas are integral to the module board. The loop for the 125 kHz RFID Reader is a
coil that is soldered to the module PWB. The antenna for the 13.56 MHz RFID Reader is a coil
traced on the module PWB.
Requirement 2.8 – Label and Compliance Information
Host Label requirement
The host product must contain a label that states the following:
Contains FCC ID: 2AQPZ-NFC2F
IC: 22140-NFC2F