User Manual

2GIG Gun Motion Detector
™
2GIG-GNGRD1-345
Read these instructions and warnings for the 2GIG Gun Motion Detector, your rearm
and your alarm system before installing or operating the 2GIG Gun Motion Detector.
Failure to do so, and/or to follow the instructions and warnings, could result in serious
injury, property damage and/or death.
INSTALLATION INSTRUCTIONS
The 2GIG Gun Motion Detector (2GIG‐GNGRD1‐345) is designed for use with certain
hand guns and ries. It communicates with the control panel using the 345 MHz
frequency. When properly installed, and the gun is moved, signals are transmitted to
the control panel. See Working With Your GoControl Panel, next page, for expected
behavior.
Figure 1: 2GIG Gun Motion Detector
Side View
Top View
Bottom View
A B
C D
Box Contents
Verify that the package includes the following:
• 1 - Gun Motion Detector
• 1 - CR2032 Battery (Installed)
Testing the Gun Motion Detector
Make sure the rearm is NOT loaded. After placing the Gun Motion Detector on a
compatible rearm, perform a motion test by simply picking it up to verify that it can
establish good Radio Frequency (RF) communications with the control panel.
Gun Motion Detector Operation
Instruction for use:
1 To open lock, set dials to combination
numbers (combination is always preset to
0-0-0 by factory).
2 With dials set to combination, move release
lever to up position.
3 Pull apart the two sides of the lock.
4 To close the lock, move release lever back
down to locked position and scramble
combination dials. Depending on your gun,
insert the front lock unit with ratchet post
through the trigger guard, behind trigger if
possible. Then insert rear unit.
Reset your personal combination:
1 Open the lock by pulling apart the two sides of the lock and completely remove
the detector from the gun.
2 Push the lever into the down position.
WARNING! DO NOT USE THIS DETECTOR ON A LOADED GUN.
• Never install the 2GIG Gun Motion Detector on a loaded rearm.
Doing so could cause an accidental discharge causing serious
injury, property damage or death.
• Store rearms and ammunition separately and securely. Keep
rearms and ammunition out of the reach of children.
• Never use a broken or damaged 2GIG Gun Motion Detector.
IMPORTANT! This product will not lock all rearms. It will block access
to many guns when properly attached. Some lever action ries, rearms without
trigger guards surrounding the triggers, guns with extra light or extra wide triggers or
guns with trigger shoes or extensions may not be able to be effectively locked with
this Gun Motion Detector. The 2GIG Gun Motion Detector may be cut or defeated by a
determined individual and may not prevent the use of a rearm.
DISCLAIMER AND LIMITATION ON DAMAGES/REMEDIES
Nortek shall not be responsible, in any manner whatsoever for any injuries, damages
or death due to the failure or malfunction of the 2GIG Gun Motion Detector, or if
applicable, the linked alarm and/or discharge of a rearm. This includes any and all
liability in any way related to criminal conduct or the failure of the alarm to detect
movement of the 2GIG Gun Motion Detector and the rearm. You, not Nortek or
this device, are solely responsible for the accidental or intentional discharge of your
rearm.
Under no circumstances will Nortek be responsible for incidental or consequential
damages. Depending on the state in which you reside, different remedies may be
available to you.
A Battery Access Cover B Motion Alert Light (Red)
C Combination Lock D Lock Release
PRINTER’S INSTRUCTIONS:
INSTR, 2GIG-GNGRD1-345 2GIG GUN MOTION DETECTOR INSTALLATION - P/N: 10021223B - INK: BLACK / C0-M100-Y100-K0 - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.500” X 11.00” - TOL. +/-.125" - SCALE: 1-1 - PRINT 2 PGS, FRONT AND BACK, FOLD TO FIT BOX
WARNING: YOU MUST FOLLOW
ALL OF THESE SAFETY RULES
TO ENSURE THE SAFE USE
OF YOUR FIREARM. THE FAILURE TO
FOLLOW THE INSTRUCTIONS AND
WARNINGS IN THIS MANUAL COULD
CAUSE SERIOUS PERSONAL INJURY
OR DEATH TO YOU OR OTHERS AND
DAMAGE PROPERTY.