User Manual

PRINTER’S INSTRUCTIONS:
GUIDE, INSTALL, QUICK,GC-DBC-1- P/N 10010716 D - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 17.000” X 11.000” - TOLERANCE: ± .125” - SCALE: 1-1 -FOLDING, FOLD 3 X TO FINAL SIZE 4.250” X 5.625” FINISH WITH LOGO SHOWING - SIDE 1 OF 2
GC-DBC-1
Installation Instructions
System Description
SMART
DOORBELL
CAMERA
DOORBELL
TRANSFORMER
CHIME BOX
WiFi ROUTER
WiFi COMMUNICATIONS
CLOUD
SMARTPHONE
Doorbell Camera Components
POWER DRILL WITH 1/4” BIT
WIRE STRIPPERS / CUTTER
PHILLIPS SCREWDRIVER
LEVEL
0-M
0.5
10
50
200
500
50
250
10
50
250
600
+-
AC VOLT METER
FLAT SCREWDRIVER
OPTIONAL
PLIERS
Tools For Installation
DIODES FOR
CHIME BOX (2)
WIRE
CONNECTORS (4)
TORX
WRENCH
TORX SCREW
SMART
DOORBELL
CAMERA
SMART DOORBELL
CAMERA MOUNTING
PLATE
PHILLIPS SCREWS
(3)
ANCHORS
(3)
Existing Doorbell Removal
• Remove existing doorbell pushbutton from location.
• Disconnect wires from back of pushbutton.
Mounting Doorbell Camera Plate
UP
OR
UP
UP
USE 1/4" (6.35mm) DRILL FOR
ANCHOR HOLES
SCREWS ONLY SCREWS & ANCHORS
MOUNTING
PLATE
• Use mounting plate as guide to mark holes.
• Use leveling tool to align mounting plate.
Wiring Doorbell Camera
1. TWIST THEN
FEED WIRES INTO
SHORT END OF
CONNECTOR
2. CRIMP WIRES
WITH PLIERS ON
SHORT END OF
CONNECTOR
CONNECTORS
IN PLACE
• Connect doorbell wires using weather-resistant wire
connectors (included).
Install Overview
BLACK WIRE: TRANSFORMER WIRE
RED WIRE: CHIME BOX WIRE
CHIME BOX
16 VAC TRANSFORMER
2
3
4
5
REAR
TRANS
FRONT
REAR
TRANS
FRONT
1 OPEN CHIME BOX
CHIME BOX FRONT VIEW WITHOUT COVER
2 INSTALL DIODE AS SHOWN
DIODE
(CATHODE
ON FRONT
TERMINAL)
IMPORTANT STEP
Installing Diode in Chime Box
✔ NOTE: Doorbell Camera is not compatible with
electronic chimes
Prepare for Installation
• Go to existing doorbell location.
• Use a Smartphone connected to the installations WiFi
router to confi rm adequate signal strength
✔ NOTE: It is recommended to TURN POWER OFF
before performing any wiring.
RED WIRE
BLACK WIRE
DIODE
16 VAC TRANSFORMER
BLACK WIRE: TRANSFORMER WIRE
RED WIRE: TO DIODE
SMART
DOORBELL
CAMERA
Wiring Camera WITHOUT Chime
(OPTIONAL)
1
PUSH EXTRA WIRE INTO
MOUNTING PLATE SLOT
HANG DOORBELL CAMERA ON
MOUNTING PLATE TAB TOPS
SLIDE DOORBELL
CAMERA “DOWN”
Camera Installation to Mounting Plate
6
VERIFY WiFi STRENGTH
VERIFY POWER SUPPLY
• The Doorbell camera works best with a 15 to 20 Volt
AC, 15 to 40 VA (Watts) supply.
• Visually inspect the doorbell transformer for power
rating (VA or Watts) and Voltage.
• Measure the doorbell wiring at the installation location
with a AC Volt meter.