Install Instructions

2GIG
®
EDGE Security & Smart Home System
2GIG-EDG-RK | Edge Remote Keypad
10030219 Rev-X3 | Proprietary & Condential
Copyright © 2020 Nortek Security & Control LLC 10030219 Rev-X3
PRINTER’S INSTRUCTIONS:
INSTALL INSTRUCTIONS, 2GIG-EDG-RK - P/N: 10030219 Rev-X3 - INK: BLACK - MATERIAL: 20 LB MEAD BOND - SIZE: 8.500” X 11.000” - TOLERANCE: ± .125” - SCALE: 1-1 - SIDE 1 OF 2
Introduction
The Remote Keypad (2GIG-EDG-RK) is a wall-mounted, full-color, touch screen interface that
provides all of the same easy-to-use keypad functions available on the Control Panel. It is
designed for indoor use only and gives users the ability to arm and disarm the system, see the
status of sensor zones, and control Smart Home devices.
Choose the Location for the 2GIG EDGE Panel’s Backplate
Before mounting the backplate, choose a location. Work with the end user to determine
the best location. Always choose an indoor location protected from temperature
extremes.
Recommended Tools and Equipment
To install the system, these tools and equipment are recommended:
➣ 2-Conductor Power Wire (if connecting power supply to the panel’s terminal block)
➣ Drywall Saw (or equivalent)
➣ Screwdrivers
➣ Staple Gun
➣ Wire Stripper
Choose the Wall Location
To choose a wall location:
➣ Always choose a location that is above ground and centrally located. Do NOT install
the Panel below ground level, because wireless range may be impaired.
➣ Do NOT connect the Panel to a light switch-controlled outlet.
➣ Avoid choosing a location that can be easily
viewed from doors or windows.
➣ Avoid choosing a location that is within reach of
small children.
➣ Avoid choosing a location in direct sunlight.
1. Align Backplate for Hole Locations
Remove the backplate from the panel by backing out
the top and bottom screws until you feel resistance.
Once removed, create mounting holes and cut a slot
in the dry wall for the AC power cord.
2. Mount the Backplate to a Wall
Use the four (4) wall anchors and screws (supplied).
NOTE: The Wall Anchor is the wall tamper and MUST be anchored to work.
4. Connect the Power Wires (Terminal Block)
Locate a wall outlet for the plug-in
power supply, but do NOT connect
the power supply to the outlet at this
time.
IMPORTANT: Never connect the
plug-in power supply to a switch-
controlled outlet. Do not over-tighten
the terminal block’s contact screws.
Power (Terminal)
Battery Backup Terminal
Power (Barrell)
LEVEL NOT LEVEL
Wall Tamper
Illustration displays both types of power connection:
2 - conductor power wires and Barrel Connector
Back Plate
Attached to Wall
Secure with Fastener
STANDARD
DECORA
5. Connect Power (Barrel Connector)
The Barrel connector is an alternate
method for connecting the AC power
supply to the Panel.
WARNING!! Do NOT plug the power
supply into the outlet at this time.
6. Connect Backup Battery
Align pins, then carefully insert the
battery cable.
7. Hang the EDGE Remote Panel
Place the backplate over the lower lip on the
back of the chassis, and ip the EDGE panel
upward and push until it clicks into place.
Secure the back plate by tightening the top
and bottom screws.
8. Install Retaining Wall Bracket and Connect the AC Power Supply
For compliance with ANSI/NFPA 70: National Electric Code in the United States, you must
install the power supply retaining bracket (not required in Canada).
FCC ID:EF400189 IC:1078A-00189