MagBak
MagBak Wireless Charger for Tesla Read this manual carefully before using this product. Also, refer to the manual of the device that will be used with this product to check for compatibility.
Installation P 1 Clean the back top left corner of the screen using the provided alcohol pad. 2 Peel off the 3M adhesive backing from the charger. 3 Carefully align the top edge of the charger and the right edge of the charger with the screen on the top left corner. NOTE: Installation video avaiable online. See the Support section for more info.
4 Press the charger to adhere it to the left edge of the screen. 5 Press the charger to adhere it to the back of the screen. Wait at least 5 minutes before attempting to use the charger to ensure proper adhesion. IMPORTANT: For optimized charging speeds use the provided PD 3.0 USB-C power adapter.
Support Scan the QR code with your camera to view installation videos and to access additional support resources online. For help with all MagBak products visit support.magbak.com or email info@1lss.com. Our support hours are Monday-Friday 9AM-5PM US Pacific Time.
FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by 1LSS INC. could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with Part 15 of the FCC Rules.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body: Use only the supplied antenna. Limitation of Liability: 1LSS INC. will not be liable for any loss or damages arising from this product, whether direct, indirect, special, incidental or consequential, regardless of the theory asserted, including warranty, contract, negligence or strict liability.
California Prop. 65 WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. www.magbak.com | support.magbak.com info@1lss.com MagBak is a registered trademark of 1LSS INC. All rights reserved. Designed in California. Made in China. 1LSS INC.