FCC ID: P27RP200N IC: 9111A-W115C ADC-W115C Alarm.
User Guide Table of Contents CHAPTER 1 INTRODUCTION.......................................................................................... 3 Package Contents .......................................................................................................... 3 Features......................................................................................................................... 3 LEDs .........................................................................................................
Chapter 1 Introduction 1 This Chapter provides an overview of the ADC-W115C’s features and capabilities. Congratulations on the purchase of your new ADC-W115C (WiFi extender). The WiFi extender is a consumer electronic device, which is designed to extend the WiFi signal for all appliances of your home, major from IP cameras, and video doorbells. It allows you to increase WiFi speed and range by taking the signal from a home router and retransmit to the furthest corner of your house.
LEDs Front Panel The ADC-W115C has 4 LEDs.
Appendix B - About Wireless LANs Rear/Side Panel Power Plug Connect the power plug to a wall socket. Reset This button has two (2) functions: • Reboot. When pressed and released, the ADC-W115C will reboot (restart). • Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Date and restore the factory default values: 1. Power On. 2. Keep holding the Reset Button down for 3 seconds. l Release the Reset Button.
Chapter 2 Initial Installation 3 2 This Chapter covers the device installation of the WiFi extender. Requirements • None of cables required for the installation. Procedure 1. Choose an Installation Site Select a suitable place to install the ADC-W115C. 2. Power Up Place the extender near the existing router. Provide the power to the extender so plug it into a wall socket or a power strip. The LEDs light will be ON and make a welcome sound to notice the extender is boot up successfully. 3.
Appendix B - About Wireless LANs • • • Allocate the extender to a near router or an AP. Power on the extender; plug it into the wall socket or a power strip. It is recommended to press the WPS button on the extender within 2 minutes after you have pressed the WPS button on your router or AP. To confirm the pairing process done successfully, check the LAN LED light is fast blinking. Also see the WPS LED light on your router, it will stark blinking.
Appendix A Specifications A ADC-W115C Model ADC-W115C (WiFi Extender with Chime) Dimensions 130mm (H) x 128mm (W) x 72mm (D) Operating Temperature 0°C - 40°C (32°F - 104°F) Buttons 2 (1 Reset, 1 WPS button) Network Protocol: TCP/IP, 802.
Regulatory Approvals IC warning statement: RF exposure related statements RF exposure warning: The equipment complies with RF exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Déclarations d'exposition aux RF liéesAvertissement d'exposition RF: L'équipement est conforme aux limites d'exposition aux RF établies pour un environnement non contrôlé.
FCC warning statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.